100x100x2.5 ball bearing butt hinge stainless steelhinge
grade 304 stainless steel
8 x 4.8 x 35mm wood screws
4 x M5 x 12mm metal thread screws
The 100 Series Architectural Hinges are designed to provide an effective solution to hanging doors where there is a need for high grade, architectural quality hinges. Produced by Assa Abloy Lockwood for Keeler Hardware.
In selecting hinges recommended in this catalogue there are a few variables which must be considered and guidelines to be observed. To determine hinge selection for individual doors, it is recommended that the guidelines contained in this catalogue are followed. When reading dimensions, the first figure always indicates the height and the second indicates the width. e.g. 100 mm x 75 mm.
The appropriate hinge height for any job is dependent upon the door width, thickness and weight. The height of the hinge is the length of the flap, not including the tips of the pin.
The door thickness and door jamb width (also trim size if applicable) determine the width of the hinge required. The width is measured across the leaves when the hinge is fully opened.
Hinges Per Door
For most internal doors two hinges will be sufficient, however, it is recommended that three hinges should be installed on doors with closers, doors likely to receive heavy use or slamming and/or external doors where the probability of warping is a consideration.If in doubt, it is advisable to install the higher number of recommended hinges to ensure job quality.
The hinge selection chart, will be most useful in selecting the correct hinge type. Simply identify the dimensions of the door to be installed and read off the recommended hinge selection. Variations to this chart will need to be made only in unusual circumstances on specific jobs or according to personal preferences. The chart is intended as a guide only and as such is not meant to be exhaustive or any more than a rule of thumb for particular applications.
|Door Height (mm)||Recommended Hinge
Selection - Broad Butt
|30mm - 45mm||Under 900mm||2024mm||
2 x 100mm x 75mm
|30mm - 45mm||Under 900mm||2024mm||
3 x 100mm x 75mm
|30mm - 45mm||Under 900mm||Between 2024mm and 2340mm||3 x 100mm x 75mm|
|30mm - 45mm||Under 900mm||Between 2024mm and 3000mm||4 x 100mm x 75mm|
|45mm - 55mm||Under 1050mm||2040mm||3 x 100mm x 100mm|
|45mm - 55mm||Under 1050mm||Between 2024mm and 2340mm||4 x 100mm x 100mm|
|45mm - 55mm||Under 1050mm||Between 2024mm and 3000mm||4 x 100mm x 100mm|
*Note: Ball bearing hinges should also be used on doors fitted with closers or automatic door operating equipment.
Heavy duty stainless steel butt hinges are recommended for commercial applications, particularly on ‘high traffic’ doors. Stainless steel ball bearing hinges should be used on heavy doors. These can generally be classified as aluminium or steel glazed doors, solid core timber doors and fire doors. Stainless steel ball bearing hinges should also be used on doors fitted with closers or automatic door operating equipment.
Fixed pin hinges should be used on exterior doors or doors opening out. Also doors made of particle should have a capped tongue edge strip framing the door, so that hinges can be screwed into a solid material.
Lockwood 100 series stainless steel and steel hinges have been successfully tested up to 4 hours on fire door assemblies in accordance with Australian Standards AS1905 Part 1 - 1997 Fire Resistant Doorsets. * Fire rating excludes fast fix hinges.
Assa Abloy Lockwood offer a 25 year product warranty for this item subject to their terms and conditions. For more information contact us.